首页 | 本学科首页   官方微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   2872篇
  免费   708篇
  国内免费   526篇
航空   2840篇
航天技术   336篇
综合类   288篇
航天   642篇
  2024年   6篇
  2023年   47篇
  2022年   102篇
  2021年   148篇
  2020年   134篇
  2019年   120篇
  2018年   113篇
  2017年   159篇
  2016年   134篇
  2015年   127篇
  2014年   205篇
  2013年   167篇
  2012年   228篇
  2011年   247篇
  2010年   219篇
  2009年   221篇
  2008年   206篇
  2007年   245篇
  2006年   209篇
  2005年   187篇
  2004年   137篇
  2003年   129篇
  2002年   107篇
  2001年   91篇
  2000年   95篇
  1999年   51篇
  1998年   54篇
  1997年   38篇
  1996年   30篇
  1995年   39篇
  1994年   25篇
  1993年   22篇
  1992年   24篇
  1991年   12篇
  1990年   10篇
  1989年   9篇
  1988年   7篇
  1987年   1篇
  1986年   1篇
排序方式: 共有4106条查询结果,搜索用时 686 毫秒
1.
2.
周觐  雷虎民  侯峰  赵炜 《宇航学报》2018,39(9):1003-1012
针对拦截高速目标的作战特点,分析了比例导引(PN)与反比例导引(RPN)的捕获区。首先,通过分析拦截弹与目标的相对运动关系,推导得到了顺轨和逆轨的零控拦截条件,此条件由目标和拦截弹的速度前置角以及二者速度比确定;其次,以拦截弹和目标速度前置角为坐标系,推导得到了PN以及RPN捕获区以及各自导航比设置范围。PN的捕获区由逆轨零控拦截条件以及与其相切且斜率为1/(N-1)的两条直线构成,RPN的捕获区由顺轨零控拦截条件以及与其相切且斜率为1/(-N-1)的两条直线构成;然后,利用函数对称性将PN与RPN捕获区转换到同一坐标区间,得到了相同条件下RPN捕获区要大于PN捕获区的结论;最后,开展了四种情形下的仿真,验证了本文捕获区分析的合理性及有效性。  相似文献   
3.
偏心撞击对撞击式喷嘴雾化特性的影响   总被引:2,自引:0,他引:2  
为研究偏心撞击对撞击式喷嘴雾化特性的影响,建立了求解自燃推进剂冷态射流撞击雾化过程的数值模拟方案,计算了不同偏心度条件下的射流撞击雾化过程。采用树形自适应加密算法直接求解不可压Navier-Stokes方程组,由分段线性的流体体积(VOF)方法对流体界面进行捕捉。结果表明偏心撞击会导致雾场发生偏转,当无量纲偏心度E为1/8时,雾场偏转角度约为9.2°,应控制加工偏差小于该值。随着偏心度的增大,液膜的偏转角度增大,理论推导得到的液膜偏转角度要小于数值计算得到的液膜偏转角度。正心撞击时燃料与氧化剂流强峰值接近,雾场的流强分布呈单峰分布。当发生偏心撞击时,由于燃料与氧化剂部分射流未参与撞击导致流强峰值出现交错,雾场的流强分布呈双峰分布,混合比的空间分布发生较大改变。正心撞击时撞击点下游液滴的速度分布近似呈轴对称分布,而偏心撞击之后的速度分布则呈中心对称分布。偏心撞击导致的射流动量损失使得雾化性能变差,当无量纲偏心度E为1/8时,一甲基肼(MMH)的Sauter平均直径增大约4.8%,四氧化二氮(NTO)的Sauter平均直径增大约5.8%。   相似文献   
4.
分别利用大气等离子喷涂技术制备了Ni/Al粘结底层、火焰喷涂技术制备了NiCrAl/Diatomite可磨耗封严涂层,研究了喷涂距离、送粉速率、火焰气体总流量、喷涂角度和氧燃比等喷涂参数对生长速率和涂层硬度的影响。结果表明,在较低的氧燃比条件下(O2∶C2H2<1.6),随着喷涂距离的增大,涂层生长速率逐渐下降,硬度先保持不变后逐渐上升;当O2∶C2H2>1.6时,涂层的生长速率会随着喷涂距离的增大先增大后减小,硬度随之逐渐下降。随着喷枪对基体相对移动速度的增大,涂层生长速率略微下降,硬度略有上升。气体总流量的增大使得涂层的生长速率明显上升,硬度明显下降。随着送粉量的增大,涂层生长速率明显提高,硬度随之先上升后下降。  相似文献   
5.
Equatorial plasma bubbles (EPBs) are common features of the equatorial and low-latitude ionosphere and are known to cause radio wave scintillation which leads to the degradation of communication and navigation systems. Although these structures have been studied for decades, a full understanding of their evolution and dynamics remains important for space weather mitigation purposes. In this study, we present cases of EPBs occurrences around April and July 2012 geomagnetic storm periods over the African equatorial sector. The EPBs were observed from the Communications/Navigation Outage Forecasting System (C/NOFS) and generally correlated well to the ionospheric irregularities observed from the Global Positioning System total electron content (GPS-TEC) measurements (rate of TEC change, ROT). This study revealed that the evolution of the EPBs during moderate storms is controlled by the strength of the daytime equatorial electrojet (EEJ) currents regardless of the strength of the equatorial ionization anomaly (EIA), the latter is observed during the July storm case in particular. These effects were more evident during the main and part of the early recovery phases of the geomagnetic storm days considered. However, the evening hours TEC gradients between regions of the magnetic equator and ionization crests also played roles in the existence of ionospheric irregularities.  相似文献   
6.
《中国航空学报》2020,33(2):391-406
A thermal-solid-liquid complex operational environment induces structural interface developing a typical coupling sliding/impact wear behavior. It results in contact damage until systems fail, which may cause significant economic losses and catastrophic consequences. The key point of solving this problem is to reveal the coupling damage mechanism of the sliding/impact behavior in typical systems and life characterization under a complicate evolving environment. This has been a hot topic in the area of mechanical reliability. The main work in this paper can be concluded as follows. Firstly, the main industries in which the “sliding/impact behavior” takes place have been introduced. Then, existing studies on the wear mechanism and degree analysis are presented, which includes surface morphology analysis, wear debris analysis, and wear degree measurement. Meanwhile, existing problems in theoretical modeling and experiments in current research are summarized, so as to point out a bright direction for future research on wear prediction. They include interface contact modeling, mathematic coupling mechanism modeling, wear equation establishment, and wear life characterization, which can provide some new ideas for improving the existing studies on the sliding/impact wear behavior.  相似文献   
7.
一种新的组合自由尾流 / CFD方法用于悬停旋翼流动的 CFD解中以考虑实际尾流的作用 .用文中描述的尾流分析方法研究了螺旋尖涡的运动 .首先从广义尾流模型开始 ,用半经验公式模化了涡核对旋翼尾流的作用 ;然后在环量收敛和尾迹收敛的条件下完成了自由尾迹计算 ;最后应用 Jameson有限体积龙格 -库塔推进格式求解了欧拉方程 .所得结果与相关文献和实验数据进行了比较  相似文献   
8.
分析了 K8、 JL8机翼接头孔精加加后与检验量规位置协调的条件,介绍了为提高它们之间协调准确度所采取的措施及其效果。  相似文献   
9.
本文在阐述基准的热力学概念基础上,提出了燃气基准的计算方法,应用CHAPPELL推荐的有关燃气热力性质表达式,导出计算燃气基准的公式,通过微机计算,将结果整理成燃气基准的有关表、图。  相似文献   
10.
对污水处理装置的技术参数、技术要求及设计方案的选择、工作原理做了进一步的阐述。对工业循环冷却水的处理有实际指导意义。  相似文献   
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号